I have an Amcrest PTZ indoor camera. I get the video stream fine. I am trying to get PTZ working. The generic android app I downloaded was able to instantly get it going, so it cannot be that difficult. I have read the docs and anything I have been able to scour. I tried ONVIF, but nothing happened. I do not think its PTZ commands are ONVIF. I have the API for the camera and found the commands:
From the web browser, this works:
The camera pans left until it hits its stop. Same for up and down and such.
On the config page, I have put in the:
I've tried GET, PUT and POST
I enabled Digest as the web page asks for the username and password. Where do I put this in the config page?
There are stop commands, so that is set to Yes.
I put in this as one command:
I get no response from the camera.