PTZ control, control URLs, not working from monitor
gismofx last edited by
I have found my PTZ control URLs and they work directly from a web browser:
It's a wansview PTZ camera
I've entered all the URLs into the control section of the settings and when I return to the monitor and enable the controls, I get no response when clicking the control buttons
Any ideas? Is there a way to debug? Is there a specific format?
A-A-Ron last edited by
Same problem. If I use http://username:[email protected]/hy-cgi/ptz.cgi?cmd=ptzctrl&act=stop in the browser, it pops up with an authentication box. If I've already signed in, I can use the url command above in a browser and it works. It seems like it's not handling authentication, even if it's specified.
Any ideas would be very welcome!
mdps last edited by
Hi, take a look of this link: http://community.netcamstudio.com/t/wansview-ncm625w-need-pan-tilt-support/842
My problem now is that it’s required to authenticate using Digest and not Basic authentication and that the implementation of Digest on this camera looks strange (it requires the parameters to be part of the uri which is apparently not how .NET consider Digest authentication has to be sent).